jobapplier

Sensor Hardware Engineer – Tactile, Audio & Vision (human)

Neura Robotics

You own the sensing stack, from first signal to production release. NEURA Robotics builds robots that have to feel, hear and see. A large part of that sits in the humanoid hand: tactile sensing in fingertips and palm, force and torque in the joints, all in a space that leaves no room for a comfortable design.

You take these sensors from concept to a characterized, calibrated, production-released design, together with our electronics, firmware, perception and mechanical engineers.

Responsibilities

  • Around it come microphone arrays for speech and acoustic events, and camera and depth modules that survive vibration, heat and tight packaging.
  • Sensor architecture: You select, specify and benchmark tactile, acoustic and optical sensors against what the robot actually needs: resolution, noise floor, latency, power, cost and supply risk.
  • Tactile and force sensing for the hand: You design and integrate tactile arrays and force/torque sensing for fingertips, palm and joints, including the low-noise analog front-ends behind them. You make sure they fit, mechanically and thermally.
  • Characterization and calibration: You run the measurement campaigns, build the fixtures, and turn your lab procedure into something production can repeat on every unit.
  • Bring-up and debugging: You lead sensor bring-up in the lab and trace problems end-to-end, from a noisy supply rail through the front-end to a perception result that looks wrong.
  • Hardware design and transfer to production: You design or co-design the sensor PCBAs and flex assemblies (depending on the product, both happen here). You own the manufacturing documentation and work with EMS partners and sensor vendors to release them for series production.
  • I²S/TDM/PDM, MIPI CSI-2, SPI, I²C, and synchronization across sensors.
  • You design the experiment, build the fixture, and know a real effect from a measurement artifact.
  • Working knowledge of Altium Designer or comparable tools for compact sensor assemblies.

Requirements

  • Firmware development is not your main job, but you can read it, write enough of it to bring a sensor up, and support the firmware team on drivers, timestamping and synchronization. With perception, you agree on what the data has to look like for their models to work.

What we can look forward to

  • You know sensors inside out, and you trust measurements over datasheets. You are hands-on, as comfortable with an analog front-end schematic as with a measurement setup, and you treat characterization and calibration as part of the design.
  • Degree in Electrical Engineering, Electronics, Mechatronics, Physics or a comparable field.
  • 3+ years with sensor hardware, with ownership from concept through characterization to production release.
  • Low-noise front-end design with instrumentation and charge amplifiers, capacitive and bridge conditioning, ADC selection, grounding and shielding.
  • Hands-on experience with at least two of the three modalities (tactile/force, audio, vision/depth), and the willingness to own all three.

Preferred

  • Fluent English; good German is a strong advantage.
  • Tactile skins, slip detection, sensing in very tight packaging.

Acoustics or optics

Arrays, beamforming, anechoic measurement, or lens selection, illumination and depth.

Sensors in harsh conditions

Vibration, thermal cycling, cable and flex fatigue.

Easy Apply